Garage Door Cable Replacement in Mundelein & Lake County, IL

Frayed & snapped lift cables replaced Licensed & insured Free estimates

Complete Garage Door Repair

Frayed or Snapped Cable? Get It Off the Door Fast

Your garage door's lift cables carry the full weight of the door as it moves, working directly against springs under heavy tension. When a cable frays, snaps, or slips off the drum, the door hangs crooked, binds in the tracks, or drops on one side—and a loose cable under that tension is genuinely dangerous. This is not a DIY fix. Our Mundelein-based technicians secure the door, safely manage the tension, and install a matched pair of new cables so both sides pull evenly. We inspect the drums, bottom brackets, and fixtures for the cause, re-tune the spring balance, and test the door end to end so it runs level and safe at every height. Because cables, springs, and rollers wear together, we often pair this with spring repair or roller replacement while we are on site.

GET IN TOUCH TODAY
Worn garage door cable bottom bracket inspected in Lake County IL
Installed in matched pairs

We replace both cables together so the door pulls evenly—no repeat visit when the second one fails.

Cable Problems We Fix

Garage door spring and cable system serviced in Mundelein IL
5 things every cable
job includes
What's included

What a Cable Replacement Includes

  • Matched cable pairs

    Both lift cables replaced together with the correct gauge and length so the door pulls evenly on each side.

  • Drum inspection & alignment

    We check the cable drums for wear and grooving and align them so the new cable seats and winds correctly.

  • Bottom bracket & fixture check

    The bottom brackets anchor the cables under load—we inspect and replace worn or bent fixtures so the anchor points hold.

  • Spring balance re-tune

    We reset the spring tension so the door is balanced—cables and springs work together, and both must be right.

  • Full safety test

    We cycle the door, check travel and balance, and confirm it runs level and safe from top to bottom before we leave.

GET A FREE ESTIMATE

Your Cable Replacement, Step by Step

Every cable job follows the same four steps, so the tension is handled safely, both cables match, and the door leaves running level—across Lake County.

  1. 01

    Secure the door & release tension

    We clamp and support the door, then safely manage the spring tension so the cables can be worked on without risk.

  2. 02

    Remove the old cables

    We take off the frayed or broken cables and inspect the drums, bottom brackets, and tracks to find why they failed.

  3. 03

    Install matched cables & check drums

    A new matched pair goes on with the correct gauge and length, seated properly on aligned drums so they wind evenly.

  4. 04

    Rebalance & safety test

    We reset the spring balance, cycle the door, and confirm level, smooth travel. Questions later? Contact us.

Complete Garage Door Repair technician on a cable replacement call in Lake County IL
100% QUALITY SATISFACTION
24/7 EMERGENCY RESPONSE AVAILABLE
Garage door hardware inspected during a cable replacement
Local coverage

Serving Lake County From Our Mundelein Office

Complete Garage Door Repair is based in Mundelein and covers homes across Lake County and North Chicagoland. Stop by, call, or send a message—we are happy to help.

  • Address1280 Townline Rd, Mundelein, IL 60060
  • Phone(224) 395-0939
  • Emailinfo@fixmygaragedoor.us
  • HoursMon–Fri: 7:00 AM – 7:00 PM
    Sat: 9:00 AM – 3:00 PM · Sun: Closed
    24/7 emergency line available

Areas We Serve

Not sure if we serve your area? Contact us—we cover the surrounding suburbs too.

Cable Replacement Questions

Yes. Lift cables work directly against the door's springs, which store enormous tension. A cable or fitting that lets go can whip loose and cause serious injury, and a door with one bad cable can drop suddenly. Cable work also requires securing the door and safely managing spring tension, so it is a job for a trained technician—closely related to our spring repair service.

Cables wear at the same rate on both sides, so if one is frayed or broken the other is usually close behind. Installing a matched pair keeps the door pulling evenly and level, prevents a repeat visit when the second cable fails, and lets us set the tension correctly on both sides at the same time.

Most cable replacements are completed in one visit of about one to two hours. That includes securing the door, removing the old cables, installing a matched new pair, checking the drums and bottom fixtures, and rebalancing the door. If the springs or drums are also worn, we will show you and give you the option to address them in the same visit.

Common causes are rust and age, misaligned or worn drums, a door that has gone off track, and the shock of a spring breaking. Moisture and years of cycling slowly fray the strands, while an alignment or track problem lets the cable slip off the drum and unwind. If your door has jumped its tracks, our off-track repair service addresses the root cause.

Yes. We release tension safely, re-seat or replace the cable, inspect the drum and track for the reason it jumped, and correct any alignment issue before rebalancing and testing the door. Book a visit on our contact page or see everything we handle on the services page.
Technician preparing a garage door cable replacement estimate

GET A QUOTE

Request a Free Estimate!